3/30/2023 0 Comments Fontforge link glyphs![]() ![]() So for the example below, the side bearings of the ‘H’ and ‘O’ are equal, but look unequal. An obvious example of this can be seen when attempting to space the characters ‘H’ and ‘O’. For example, whilst the measurements between two characters may be unequal, the eye can see them as equal. The bottom line is to ‘design, look, adjust, look again’.įor the absolute beginner, do not assume that reliable results are achieved by relying on the measured space. ![]() Note though that this is not a hard and fast rule, but a general one.Īs you space the characters that you design, you should trust your eyes. General PrinciplesĪs a general principle, symmetric characters such as ‘A’ ‘H’ ‘I’ ‘M’ ‘N’ ‘O’ ‘T’ ‘U’ ‘V’ ‘W’ ‘X’ ‘Y’ ‘o’ ‘v’ ‘w’ ‘x’ will have symmetric side bearings, e.g., the left and right side bearings of an ‘H’ will be the same value. ![]() The up and down keys are used to increment / decrement values and Alt + Up, Alt + Down, Alt + Left and Alt + Right are used for navigating around the different value fields of the Metrics Window. One method of adjusting metric values quickly and accurately in FontForge is by using the up, down, left and right keys of a keyboard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |